Written by
Maren Coleman Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeFCE2
ApplianceMicrowave
FCE2 at a glance
A network message for over-the-range microwaves and ranges: the unit failed to reach the router. Possible causes in Whirlpool’s product help:
connection time out
weak signal strength
router failure
the appliance’s Wi-Fi Module
wiring that goes with the module
Steps in order
Cycle the power: breaker off for a minute (unplugging also works), then back on. Keep an eye on the display for a minute, and verify the appliance operates.
If the Wi-Fi Module cannot link to the wireless router, reset the router.
Check that some other device with Wi-Fi works. Carry a smartphone or tablet next to the appliance and see if it stays connected there.
Should both be fine, power the router down for 2 minutes and restart it. Then power the appliance down for 2 minutes and restart it.
Signal is weak
Not seeing full bars beside the appliance? Choose from relocating the router, a compatible signal extender, or your Internet Service Provider.
FCE3 reads the same too, with identical possible causes.
FCE7 says the appliance did not connect to your router and also covers wall ovens.
Whirlpool microwave repair in San Francisco
FCE2 that keeps coming back after the router and breaker resets is a job for Whirlpool microwave repair in San Francisco and around the Bay Area. Call (415) 687-4102 and have the code, the model number and the router steps you already ran ready.
Model compatibility: Whirlpool reuses codes across series and model years, so FCE2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
The appliance could not connect to the router.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Whirlpool appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Whirlpool WMH32519HZ over-the-range steam microwave repair in San Francisco: no heat, dead keypad, weak vent fan, light out, humidity sensor and overheating…
Whirlpool WML75011HZ low-profile over-the-range microwave repair in San Francisco: no heat, dead keypad, turntable trouble, weak fan and sensor error codes.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Whirlpool appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
