Written by
Maren Coleman Appliance Care EditorPublished October 29, 2026
VERIFIED
Error codeF8E6
ApplianceWasher
The same code, a different story depending on the machine. Whirlpool gives F8E6 one meaning for laundry towers and two for top loaders, so work out which washer you own first.
On a laundry tower
The potential cause is listed as water detected.
Reset the control by disconnecting power for 5 minutes, then reconnect.
A returning code means it is time to book a technician.
On a top load washer
Depending on the model, the code points to either of these:
The lid was open during the soak cycle. Shut it and the cycle carries on.
No hot water was detected. The checks below apply.
Checks for the no-hot-water reading
Inspect the hoses. The code can appear when the cold hose is attached to the hot inlet and the hot hose to the cold inlet. Swap them and run another cycle.
Make sure both water valves are opened fully and that a hose is attached to each inlet.
Reset the control: unplug the washer, wait 5 minutes and plug it in once more.
If F8E6 will not go away, Whirlpool washer repair is available for San Francisco and Bay Area households. Call (415) 687-4102 and say whether your washer is a tower or a top loader, then give the model number and the hose, valve and reset steps you went through.
Model compatibility: Whirlpool reuses codes across series and model years, so F8E6 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F8E6 means water detected on laundry tower washers; on top loaders it means an open lid in soak or no hot water detected.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Whirlpool appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Whirlpool appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
