Whirlpool Compact Heat Pump Dryer FE Error Code
FE is a power source problem on compact heat pump dryers; check the outlet first.
Model Reference
Whirlpool WED6620H Vented Electric Dryer Repair in San Francisco
Steam dryer owners often find a damp load or a drum that stops, and the Wrinkle Shield runs longer than expected.
- 10 appliance guides
- 102 model pages
- 486 error codes explained
- 150 Bay Area places
- Mon–Sat 8:00 AM – 7:00 PM
Model number
WED6620H
About this model
Model overview
The Whirlpool WED6620H is a 27-inch front-load electric dryer with a 7.4 cubic foot drum and steam options. Steam Refresh handles wrinkles and odors, and Wrinkle Shield Plus adds steam to post-cycle tumbling for up to 150 minutes. A Static Reduce option is included, along with Control Lock and a Damp Dry Signal. The exhaust can leave to the left, right, below or behind the unit, which changes how the dryer sits in a room. Across the Bay Area, calls most often concern a drum that will not turn, squealing, or no heat. Letters after WED6620H on the label belong to the number, so in the booking form give the full string with the symptom and any code.
Specifications
| Dimensions | Overall width is 27 inches. |
|---|---|
| Capacity | Drying capacity is 7.4 cu. ft. |
| Power | Electrical rating is 240 volts, 60Hz and 30 amps. |
| Installation | Exhaust can be routed left, right, below or behind the dryer. |
| Features | Steam Refresh is an available cycle. A Static Reduce option is included. Wrinkle Shield Plus uses tumbling and steam for up to 150 minutes after drying or until the door opens. |
| Controls | Control Lock and Damp Dry Signal are available options. |
| Finish | WED6620HW has a white exterior. |
What sets the WED6620H apart
Steam appears in two places on this model, once in Steam Refresh and again in Wrinkle Shield Plus after drying, so the steam path works twice per load. Static Reduce is a separate option for the end of the cycle. Control Lock and the Damp Dry Signal are optional extras that change how the panel behaves. Day to day, a long post-cycle steam tumble can make the dryer seem to run after the load is ready.
What owners notice
- Drum not turning.
- Squealing, thumping or grinding.
- No heat or overheating.
- Cycle ends too early.
Service notes for the WED6620H
A drum that will not turn is checked for belt condition, the roller set and the drive motor with power off. Squealing or thumping points to the same rollers. No heat is traced to the heating element and its thermal cutoff, with the 240-volt, 30-amp supply confirmed. Steam faults are checked along the steam path so a steam cycle is not mistaken for a heating fault. Ahead of a visit, an owner can confirm the exhaust route matches the installation guide, clear the lint screen, and check that Control Lock is not locking the panel.
Booking
We confirm the full model number, test the parts linked to the symptom and give a written estimate. Nothing is repaired without your approval. Related pages: Whirlpool Dryer Repair in San Francisco and Whirlpool Dryers.
Frequently asked questions
It tumbles with steam for up to 150 minutes after drying, or until the door is opened.
Yes, the exhaust can be routed left, right, below or behind the dryer.
Check the rating label around the door opening or on the back panel. Copy every letter and digit, including the ones at the end.
Yes. We book in-home visits for this model in San Francisco and the Bay Area. Add the model number and the symptom to the booking form.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Diagnostics
Error codes for this appliance
Fix it right
Repair service
Dryer Repair in San Francisco
Gas, electric and ventless Whirlpool dryers diagnosed across San Francisco and the Bay Area, with a written estimate before any repair begins.
Models
Other models
Book a repair
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Phone
(415) 687-4102
Hours
Mon–Sat: 8:00 AM – 7:00 PM
Service area
San Francisco Bay Area, California